110Xi4 Control Panel

  1. Home
  2. Knowledge Base
  3. Mobile Printers
  4. Zebra 110Xi4
  5. 110Xi4 Control Panel

Zebra 110Xi4 Control Panel

All controls and indicators are located on the control panel of your Zebra 110Xi4 printer.

  • The control panel Liquid Crystal Display (LCD) shows the operating status and printer parameters.
  • The control panel buttons are used to control the printer operations and to set parameters.
  • The control panel lights (LEDs) show the printer’s operating status or indicate which control panel buttons are active.

 1  Power light On when the printer is on
 2  PAUSE light On when the printer is paused
 3  Error light Off – Normal operation, no printer errors

Blinking – A printer error exists. Check LCD for more information

 4  Data light Off – Normal operation, no data being received or processed

On – The printer is processing data or is printing

Blinking quickly – The printer is receiving data from or sending status information to the host computer

 5  LCD The control panel LCD functions differently in different printer modes

  • In Operating mode, the LCD displays the printer’s status, sometimes in conjunction with a control panel light
  • In Pause mode, the printer stops printing temporarily
  • In Setup mode, you can use the control panel LCD to view or modify printer parameters
  • In Error mode, the LCD may display an alert or error message
 6  PLUS (+) Changes the parameter values. Common uses are to increase a value, to answer “yes,” to scroll through choices, or to change values while entering the printer password
 7  PREVIOUS When in Setup mode, scrolls the LCD to the previous parameter. Press and hold to scroll quickly
 8  MINUS (-) Changes the parameter values. Common uses are to decrease a value, to answer “no,” to scroll through choices, or to change the cursor position while entering the printer password
 9 SETUP/EXIT Enters and exits Setup mode
 10  NEXT/SAVE
  • When in Setup mode, scrolls the LCD to the next parameter. Press and hold to scroll quickly
  • When exiting Setup mode, saves any changes that you made in the configuration
    and calibration sequence
 11  CALIBRATE  Calibrates the printer for the following

  • Media length
  • Media type (continuous or non-continuous)
  • Print method (direct thermal or thermal transfer)
  • Sensor values
 12  PAUSE Starts or stops the printer operation or removes error messages and clears the LCD

  • If the printer is idle, it enters Pause mode immediately
  • If the printer is printing, the label is completed before the printer pauses
 13  FEED  Forces the printer to feed one blank label each time the button is pressed

  • If the printer is idle or paused, the label is fed immediately
  • If the printer is printing, the label is fed after printing finishes
 14  CANCEL  Cancels print jobs when the printer is paused

Pressing CANCEL once has these effects

  • Cancels the label format that is currently printing
  • If no label format is printing, the next one to be printed is canceled
  • If no label formats are waiting to be printed, CANCEL is ignored

Pressing and holding CANCEL clears the printer’s entire label format memory. When the formats are cleared, the DATA light turns off

 

 

 

Was this article helpful?

Related Articles