LS9208 Beeper Volume

  1. Home
  2. Knowledge Base
  3. Barcode Scanners
  4. Motorola LS9208
  5. LS9208 Beeper Volume

Motorola LS9208 Beeper Volume

Your Motorola LS9208 scanner emits a short beep when it successfully reads a bar code. You can change the volume using the trigger by following the below steps.

  1. Press and hold the trigger for an extended period of time (approximately 5 seconds). The scanner cycles through three settings (Low, Medium, High) emitting a 2-beep tone at each setting.
  2. To select a particular setting, release the trigger after you hear the desired 2-beep tone.

 

Was this article helpful?

Related Articles